Wieland ZENOTEC FIRE P1

$8,122.00

Category:

Description

Zenotec Fire P1 fast sintering program:
! Only suitable for Zenostar T/MO single-tooth restorations !
Temperature 1 [°C] / [°F] Temperature 2 [°C] / [°F] Heating rate [°C/h] / [°F/h] Holding time [h]
Heating phase 20 / 68 1520 / 2768 1500 / 2732 –
Holding phase 1520 / 2768 1520 / 2768 – 0.5
Cooling phase 1520 / 2768 300 / 572 800 / 1472 –

For the sintering process in the Zenotec high-temperature furnaces, the following points should be observed:
 If a standard program is used, it is recommended to sinter the restorations on a sintering support base plate under a highpurity
Al2O3 cover. This arrangement helps prevent deformation and discoloration from occurring in the restoration. All
standard sintering programs are matched to this configuration.
 If a fast sintering program is used, only the sintering support base plate – without the cover – must be used. Fast sintering
is only suitable for ZenostarT/MO single-tooth restorations.
 Check sintering auxiliaries regularly to make sure that they are clean and work properly

Reviews

There are no reviews yet.

Be the first to review “Wieland ZENOTEC FIRE P1”

Your email address will not be published. Required fields are marked *